HOME | ABOUT US | CERTIFICATIONS | CATALOG | CONTACT US | REQUEST QUOTE
Translate This Page
Featured
 
 
 

#2 Vent Master Flash® Pipe Flashing

Accommodates 50-70mm pipes

WEATHER PROTECTION
Made of EPDM or Silicone, these flashings are compounded specifically for maximum resistance to weathering due to ozone and ultraviolet light.

EASY ON-SITE CUSTOMIZING
Fast, one piece construction allows for easy on-siteinstallation in usually 5 minutes.

BASE FLEXIBILITY
The base is designed to form a seal on most panel configurations and roof pitches regardless of pipe location.

 
TWO COMPOUNDS / 2 COLORS
Availiable in two compounds to handle virtually all job applications
    EPDM 500 SILICONE
 
ADVANCED OZONE RESISTANCE tested to... 70 hour @ 500 pphm 70 hour @ 500 pphm
 
HIGH TEMPERATURE RESISTANCE
 
tested to intermittent • +135ºC (+275ºF) • +260ºC (+500ºF)
  continuous • +100ºC (+212ºF) • +225ºC (+437ºF)
 
LOW TEMPERATURE RESISTANCE tested to… • +50ºC (-67ºF) • -74ºC (-101ºF)
 
TENSILE SET minimum… 10MPa  (1450psi) 5 Mpa (700 psi)
Complete specification data and testing methods are availiable upon request
 
flashing calculatorTry our new Master Flash Roof Pitch Calculator which is designed specifically for Master Flash® products. Using this calculator in association with foreign or competitive products may result in installation failure. This Calculator is designed to provide assistance in planning only. It is to be used as a guide and not the ultimate source of information. Every effort has been made to make this as complete and accurate as possible. If you are installing on pitches greater than 10/12 or you desire further information, please call Aztec Washer: 1-800-WASHER-5.
 
Sizing Chart
Check diameter of pipe. Select the appropiate #2-Vent Master Flash® for pipe or duct diameter. For extreme pitch or surface irregularity select next larger size. Choose the compound required, then refer to the part number for the #2-Vent Master Flash® desired.

PIPE SIZE
US PART NUM FLASHING DETAILS
#2-VENT 2"-2-3/4" Black EPDM SV101BA A-Top opening diameter Closed

(50-70mm) Grey EPDM SV101GA B-Cut to suit pipe size 1/8” – 3/4” (3-19mm)


Red Silicone SV101RA C-Base dimensions 2-1/4” (57mm)
 
   
 
   
 

13821 Danielson St., Poway, California 92064 | 1-800-WASHER 5 (927-4375) | 1-858-513-4350 | Fax 1-858-513-4305

Master Flash®, Universal Master Flash®, Universal Retrofit Master Flash®, Retrofit Master Flash®, Residential Master Flash®,
Square Vent Retrofit Master Flash®, Master Seal® and Master Plug® are registered trademarks of Aztec Washer Company, Inc.
©2009-2014 Aztec Washer Company, Inc. | Site Map | Privacy Statement
Please Note: Aztec Washer industry leading metal roof flashings and pipe flashing products for residential and commercial projects are available online from trusted retailers.